1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
|
#ifndef _EPIC100_H_
# define _EPIC100_H_
#ifndef PCI_VENDOR_SMC
# define PCI_VENDOR_SMC 0x10B8
#endif
#ifndef PCI_DEVICE_SMC_EPIC100
# define PCI_DEVICE_SMC_EPIC100 0x0005
#endif
#define PCI_DEVICE_ID_NONE 0xFFFF
/* Offsets to registers (using SMC names). */
enum epic100_registers {
COMMAND= 0, /* Control Register */
INTSTAT= 4, /* Interrupt Status */
INTMASK= 8, /* Interrupt Mask */
GENCTL = 0x0C, /* General Control */
NVCTL = 0x10, /* Non Volatile Control */
EECTL = 0x14, /* EEPROM Control */
TEST = 0x1C, /* Test register: marked as reserved (see in source code) */
CRCCNT = 0x20, /* CRC Error Counter */
ALICNT = 0x24, /* Frame Alignment Error Counter */
MPCNT = 0x28, /* Missed Packet Counter */
MMCTL = 0x30, /* MII Management Interface Control */
MMDATA = 0x34, /* MII Management Interface Data */
MIICFG = 0x38, /* MII Configuration */
IPG = 0x3C, /* InterPacket Gap */
LAN0 = 0x40, /* MAC address. (0x40-0x48) */
IDCHK = 0x4C, /* BoardID/ Checksum */
MC0 = 0x50, /* Multicast filter table. (0x50-0x5c) */
RXCON = 0x60, /* Receive Control */
TXCON = 0x70, /* Transmit Control */
TXSTAT = 0x74, /* Transmit Status */
PRCDAR = 0x84, /* PCI Receive Current Descriptor Address */
PRSTAT = 0xA4, /* PCI Receive DMA Status */
PRCPTHR= 0xB0, /* PCI Receive Copy Threshold */
PTCDAR = 0xC4, /* PCI Transmit Current Descriptor Address */
ETHTHR = 0xDC /* Early Transmit Threshold */
};
/* Command register (CR_) bits */
#define CR_STOP_RX (0x00000001)
#define CR_START_RX (0x00000002)
#define CR_QUEUE_TX (0x00000004)
#define CR_QUEUE_RX (0x00000008)
#define CR_NEXTFRAME (0x00000010)
#define CR_STOP_TX_DMA (0x00000020)
#define CR_STOP_RX_DMA (0x00000040)
#define CR_TX_UGO (0x00000080)
/* Interrupt register bits. NI means No Interrupt generated */
#define INTR_RX_THR_STA (0x00400000) /* rx copy threshold status NI */
#define INTR_RX_BUFF_EMPTY (0x00200000) /* rx buffers empty. NI */
#define INTR_TX_IN_PROG (0x00100000) /* tx copy in progess. NI */
#define INTR_RX_IN_PROG (0x00080000) /* rx copy in progress. NI */
#define INTR_TXIDLE (0x00040000) /* tx idle. NI */
#define INTR_RXIDLE (0x00020000) /* rx idle. NI */
#define INTR_INTR_ACTIVE (0x00010000) /* Interrupt active. NI */
#define INTR_RX_STATUS_OK (0x00008000) /* rx status valid. NI */
#define INTR_PCI_TGT_ABT (0x00004000) /* PCI Target abort */
#define INTR_PCI_MASTER_ABT (0x00002000) /* PCI Master abort */
#define INTR_PCI_PARITY_ERR (0x00001000) /* PCI adress parity error */
#define INTR_PCI_DATA_ERR (0x00000800) /* PCI data parity error */
#define INTR_RX_THR_CROSSED (0x00000400) /* rx copy threshold crossed */
#define INTR_CNTFULL (0x00000200) /* Counter overflow */
#define INTR_TXUNDERRUN (0x00000100) /* tx underrun. */
#define INTR_TXEMPTY (0x00000080) /* tx queue empty */
#define INTR_TX_CH_COMPLETE (0x00000040) /* tx chain complete */
#define INTR_TXDONE (0x00000020) /* tx complete (w or w/o err) */
#define INTR_RXERROR (0x00000010) /* rx error (CRC) */
#define INTR_RXOVERFLOW (0x00000008) /* rx buffer overflow */
#define INTR_RX_QUEUE_EMPTY (0x00000004) /* rx queue empty. */
#define INTR_RXHEADER (0x00000002) /* header copy complete */
#define INTR_RXDONE (0x00000001) /* Receive copy complete */
#define INTR_CLEARINTR (0x00007FFF)
#define INTR_VALIDBITS (0x007FFFFF)
#define INTR_DISABLE (0x00000000)
#define INTR_CLEARERRS (0x00007F18)
#define INTR_ABNINTR (INTR_CNTFULL | INTR_TXUNDERRUN | INTR_RXOVERFLOW)
/* General Control (GC_) bits */
#define GC_SOFT_RESET (0x00000001)
#define GC_INTR_ENABLE (0x00000002)
#define GC_SOFT_INTR (0x00000004)
#define GC_POWER_DOWN (0x00000008)
#define GC_ONE_COPY (0x00000010)
#define GC_BIG_ENDIAN (0x00000020)
#define GC_RX_PREEMPT_TX (0x00000040)
#define GC_TX_PREEMPT_RX (0x00000080)
/*
* Receive FIFO Threshold values
* Control the level at which the PCI burst state machine
* begins to empty the receive FIFO. Possible values: 0-3
*
* 0 => 32, 1 => 64, 2 => 96 3 => 128 bytes.
*/
#define GC_RX_FIFO_THR_32 (0x00000000)
#define GC_RX_FIFO_THR_64 (0x00000100)
#define GC_RX_FIFO_THR_96 (0x00000200)
#define GC_RX_FIFO_THR_128 (0x00000300)
/* Memory Read Control (MRC_) values */
#define GC_MRC_MEM_READ (0x00000000)
#define GC_MRC_READ_MULT (0x00000400)
#define GC_MRC_READ_LINE (0x00000800)
#define GC_SOFTBIT0 (0x00001000)
#define GC_SOFTBIT1 (0x00002000)
#define GC_RESET_PHY (0x00004000)
/* Definitions of the Receive Control (RC_) register bits */
#define RC_SAVE_ERRORED_PKT (0x00000001)
#define RC_SAVE_RUNT_FRAMES (0x00000002)
#define RC_RCV_BROADCAST (0x00000004)
#define RC_RCV_MULTICAST (0x00000008)
#define RC_RCV_INVERSE_PKT (0x00000010)
#define RC_PROMISCUOUS_MODE (0x00000020)
#define RC_MONITOR_MODE (0x00000040)
#define RC_EARLY_RCV_ENABLE (0x00000080)
/* description of the rx descriptors control bits */
#define RD_FRAGLIST (0x0001) /* Desc points to a fragment list */
#define RD_LLFORM (0x0002) /* Frag list format */
#define RD_HDR_CPY (0x0004) /* Desc used for header copy */
/* Definition of the Transmit CONTROL (TC) register bits */
#define TC_EARLY_TX_ENABLE (0x00000001)
/* Loopback Mode (LM_) Select valuesbits */
#define TC_LM_NORMAL (0x00000000)
#define TC_LM_INTERNAL (0x00000002)
#define TC_LM_EXTERNAL (0x00000004)
#define TC_LM_FULL_DPX (0x00000006)
#define TX_SLOT_TIME (0x00000078)
/* Bytes transferred to chip before transmission starts. */
#define TX_FIFO_THRESH 128 /* Rounded down to 4 byte units. */
/* description of rx descriptors status bits */
#define RRING_PKT_INTACT (0x0001)
#define RRING_ALIGN_ERR (0x0002)
#define RRING_CRC_ERR (0x0004)
#define RRING_MISSED_PKT (0x0008)
#define RRING_MULTICAST (0x0010)
#define RRING_BROADCAST (0x0020)
#define RRING_RECEIVER_DISABLE (0x0040)
#define RRING_STATUS_VALID (0x1000)
#define RRING_FRAGLIST_ERR (0x2000)
#define RRING_HDR_COPIED (0x4000)
#define RRING_OWN (0x8000)
/* error summary */
#define RRING_ERROR (RRING_ALIGN_ERR|RRING_CRC_ERR)
/* description of tx descriptors status bits */
#define TRING_PKT_INTACT (0x0001) /* pkt transmitted. */
#define TRING_PKT_NONDEFER (0x0002) /* pkt xmitted w/o deferring */
#define TRING_COLL (0x0004) /* pkt xmitted w collisions */
#define TRING_CARR (0x0008) /* carrier sense lost */
#define TRING_UNDERRUN (0x0010) /* DMA underrun */
#define TRING_HB_COLL (0x0020) /* Collision detect Heartbeat */
#define TRING_WIN_COLL (0x0040) /* out of window collision */
#define TRING_DEFERRED (0x0080) /* Deferring */
#define TRING_COLL_COUNT (0x0F00) /* collision counter (mask) */
#define TRING_COLL_EXCESS (0x1000) /* tx aborted: excessive colls */
#define TRING_OWN (0x8000) /* desc ownership bit */
/* error summary */
#define TRING_ABORT (TRING_COLL_EXCESS|TRING_WIN_COLL|TRING_UNDERRUN)
#define TRING_ERROR (TRING_DEFERRED|TRING_WIN_COLL|TRING_UNDERRUN|TRING_CARR/*|TRING_COLL*/ )
/* description of the tx descriptors control bits */
#define TD_FRAGLIST (0x0001) /* Desc points to a fragment list */
#define TD_LLFORM (0x0002) /* Frag list format */
#define TD_IAF (0x0004) /* Generate Interrupt after tx */
#define TD_NOCRC (0x0008) /* No CRC generated */
#define TD_LASTDESC (0x0010) /* Last desc for this frame */
#endif /* _EPIC100_H_ */
|
