diff options
Diffstat (limited to 'drivers/net/wireless/b43/b43.h')
| -rw-r--r-- | drivers/net/wireless/b43/b43.h | 211 |
1 files changed, 114 insertions, 97 deletions
diff --git a/drivers/net/wireless/b43/b43.h b/drivers/net/wireless/b43/b43.h index 40448067e4cc..660716214d49 100644 --- a/drivers/net/wireless/b43/b43.h +++ b/drivers/net/wireless/b43/b43.h @@ -142,6 +142,17 @@ #define B43_BFL_BTCMOD 0x4000 /* BFL_BTCOEXIST is given in alternate GPIOs */ #define B43_BFL_ALTIQ 0x8000 /* alternate I/Q settings */ +/* SPROM boardflags_hi values */ +#define B43_BFH_NOPA 0x0001 /* has no PA */ +#define B43_BFH_RSSIINV 0x0002 /* RSSI uses positive slope (not TSSI) */ +#define B43_BFH_PAREF 0x0004 /* uses the PARef LDO */ +#define B43_BFH_3TSWITCH 0x0008 /* uses a triple throw switch shared + * with bluetooth */ +#define B43_BFH_PHASESHIFT 0x0010 /* can support phase shifter */ +#define B43_BFH_BUCKBOOST 0x0020 /* has buck/booster */ +#define B43_BFH_FEM_BT 0x0040 /* has FEM and switch to share antenna + * with bluetooth */ + /* GPIO register offset, in both ChipCommon and PCI core. */ #define B43_GPIO_CONTROL 0x6c @@ -482,6 +493,10 @@ enum { /* Max size of a security key */ #define B43_SEC_KEYSIZE 16 +/* Max number of group keys */ +#define B43_NR_GROUP_KEYS 4 +/* Max number of pairwise keys */ +#define B43_NR_PAIRWISE_KEYS 50 /* Security algorithms. */ enum { B43_SEC_ALGO_NONE = 0, /* unencrypted, as of TX header. */ @@ -592,80 +607,7 @@ struct b43_qos_params { struct ieee80211_tx_queue_params p; }; -struct b43_wldev; - -/* Data structure for the WLAN parts (802.11 cores) of the b43 chip. */ -struct b43_wl { - /* Pointer to the active wireless device on this chip */ - struct b43_wldev *current_dev; - /* Pointer to the ieee80211 hardware data structure */ - struct ieee80211_hw *hw; - - /* The number of queues that were registered with the mac80211 subsystem - * initially. This is a backup copy of hw->queues in case hw->queues has - * to be dynamically lowered at runtime (Firmware does not support QoS). - * hw->queues has to be restored to the original value before unregistering - * from the mac80211 subsystem. */ - u16 mac80211_initially_registered_queues; - - struct mutex mutex; - spinlock_t irq_lock; - /* R/W lock for data transmission. - * Transmissions on 2+ queues can run concurrently, but somebody else - * might sync with TX by write_lock_irqsave()'ing. */ - rwlock_t tx_lock; - /* Lock for LEDs access. */ - spinlock_t leds_lock; - /* Lock for SHM access. */ - spinlock_t shm_lock; - - /* We can only have one operating interface (802.11 core) - * at a time. General information about this interface follows. - */ - - struct ieee80211_vif *vif; - /* The MAC address of the operating interface. */ - u8 mac_addr[ETH_ALEN]; - /* Current BSSID */ - u8 bssid[ETH_ALEN]; - /* Interface type. (IEEE80211_IF_TYPE_XXX) */ - int if_type; - /* Is the card operating in AP, STA or IBSS mode? */ - bool operating; - /* filter flags */ - unsigned int filter_flags; - /* Stats about the wireless interface */ - struct ieee80211_low_level_stats ieee_stats; - -#ifdef CONFIG_B43_HWRNG - struct hwrng rng; - bool rng_initialized; - char rng_name[30 + 1]; -#endif /* CONFIG_B43_HWRNG */ - - /* List of all wireless devices on this chip */ - struct list_head devlist; - u8 nr_devs; - - bool radiotap_enabled; - bool radio_enabled; - - /* The beacon we are currently using (AP or IBSS mode). - * This beacon stuff is protected by the irq_lock. */ - struct sk_buff *current_beacon; - bool beacon0_uploaded; - bool beacon1_uploaded; - bool beacon_templates_virgin; /* Never wrote the templates? */ - struct work_struct beacon_update_trigger; - - /* The current QOS parameters for the 4 queues. */ - struct b43_qos_params qos_params[4]; - - /* Work for adjustment of the transmission power. - * This is scheduled when we determine that the actual TX output - * power doesn't match what we want. */ - struct work_struct txpower_adjust_work; -}; +struct b43_wl; /* The type of the firmware file. */ enum b43_firmware_file_type { @@ -739,14 +681,6 @@ enum { smp_wmb(); \ } while (0) -/* XXX--- HOW LOCKING WORKS IN B43 ---XXX - * - * You should always acquire both, wl->mutex and wl->irq_lock unless: - * - You don't need to acquire wl->irq_lock, if the interface is stopped. - * - You don't need to acquire wl->mutex in the IRQ handler, IRQ tasklet - * and packet TX path (and _ONLY_ there.) - */ - /* Data structure for one wireless device (802.11 core) */ struct b43_wldev { struct ssb_device *dev; @@ -755,13 +689,10 @@ struct b43_wldev { /* The device initialization status. * Use b43_status() to query. */ atomic_t __init_status; - /* Saved init status for handling suspend. */ - int suspend_init_status; bool bad_frames_preempt; /* Use "Bad Frames Preemption" (default off) */ bool dfq_valid; /* Directed frame queue valid (IBSS PS mode, ATIM) */ bool radio_hw_enable; /* saved state of radio hardware enabled state */ - bool suspend_in_progress; /* TRUE, if we are in a suspend/resume cycle */ bool qos_enabled; /* TRUE, if QoS is used. */ bool hwcrypto_enabled; /* TRUE, if HW crypto acceleration is enabled. */ @@ -781,25 +712,17 @@ struct b43_wldev { /* Various statistics about the physical device. */ struct b43_stats stats; - /* The device LEDs. */ - struct b43_led led_tx; - struct b43_led led_rx; - struct b43_led led_assoc; - struct b43_led led_radio; - /* Reason code of the last interrupt. */ u32 irq_reason; u32 dma_reason[6]; /* The currently active generic-interrupt mask. */ u32 irq_mask; + /* Link Quality calculation context. */ struct b43_noise_calculation noisecalc; /* if > 0 MAC is suspended. if == 0 MAC is enabled. */ int mac_suspended; - /* Interrupt Service Routine tasklet (bottom-half) */ - struct tasklet_struct isr_tasklet; - /* Periodic tasks */ struct delayed_work periodic_work; unsigned int periodic_state; @@ -808,8 +731,7 @@ struct b43_wldev { /* encryption/decryption */ u16 ktp; /* Key table pointer */ - u8 max_nr_keys; - struct b43_key key[58]; + struct b43_key key[B43_NR_GROUP_KEYS * 2 + B43_NR_PAIRWISE_KEYS]; /* Firmware data */ struct b43_firmware fw; @@ -820,9 +742,104 @@ struct b43_wldev { /* Debugging stuff follows. */ #ifdef CONFIG_B43_DEBUG struct b43_dfsentry *dfsentry; + unsigned int irq_count; + unsigned int irq_bit_count[32]; + unsigned int tx_count; + unsigned int rx_count; #endif }; +/* + * Include goes here to avoid a dependency problem. + * A better fix would be to integrate xmit.h into b43.h. + */ +#include "xmit.h" + +/* Data structure for the WLAN parts (802.11 cores) of the b43 chip. */ +struct b43_wl { + /* Pointer to the active wireless device on this chip */ + struct b43_wldev *current_dev; + /* Pointer to the ieee80211 hardware data structure */ + struct ieee80211_hw *hw; + + /* Global driver mutex. Every operation must run with this mutex locked. */ + struct mutex mutex; + /* Hard-IRQ spinlock. This lock protects things used in the hard-IRQ + * handler, only. This basically is just the IRQ mask register. */ + spinlock_t hardirq_lock; + + /* The number of queues that were registered with the mac80211 subsystem + * initially. This is a backup copy of hw->queues in case hw->queues has + * to be dynamically lowered at runtime (Firmware does not support QoS). + * hw->queues has to be restored to the original value before unregistering + * from the mac80211 subsystem. */ + u16 mac80211_initially_registered_queues; + + /* We can only have one operating interface (802.11 core) + * at a time. General information about this interface follows. + */ + + struct ieee80211_vif *vif; + /* The MAC address of the operating interface. */ + u8 mac_addr[ETH_ALEN]; + /* Current BSSID */ + u8 bssid[ETH_ALEN]; + /* Interface type. (NL80211_IFTYPE_XXX) */ + int if_type; + /* Is the card operating in AP, STA or IBSS mode? */ + bool operating; + /* filter flags */ + unsigned int filter_flags; + /* Stats about the wireless interface */ + struct ieee80211_low_level_stats ieee_stats; + +#ifdef CONFIG_B43_HWRNG + struct hwrng rng; + bool rng_initialized; + char rng_name[30 + 1]; +#endif /* CONFIG_B43_HWRNG */ + + /* List of all wireless devices on this chip */ + struct list_head devlist; + u8 nr_devs; + + bool radiotap_enabled; + bool radio_enabled; + + /* The beacon we are currently using (AP or IBSS mode). */ + struct sk_buff *current_beacon; + bool beacon0_uploaded; + bool beacon1_uploaded; + bool beacon_templates_virgin; /* Never wrote the templates? */ + struct work_struct beacon_update_trigger; + + /* The current QOS parameters for the 4 queues. */ + struct b43_qos_params qos_params[4]; + + /* Work for adjustment of the transmission power. + * This is scheduled when we determine that the actual TX output + * power doesn't match what we want. */ + struct work_struct txpower_adjust_work; + + /* Packet transmit work */ + struct work_struct tx_work; + /* Queue of packets to be transmitted. */ + struct sk_buff_head tx_queue; + + /* The device LEDs. */ + struct b43_leds leds; + +#ifdef CONFIG_B43_PIO + /* + * RX/TX header/tail buffers used by the frame transmit functions. + */ + struct b43_rxhdr_fw4 rxhdr; + struct b43_txhdr txhdr; + u8 rx_tail[4]; + u8 tx_tail[4]; +#endif /* CONFIG_B43_PIO */ +}; + static inline struct b43_wl *hw_to_b43_wl(struct ieee80211_hw *hw) { return hw->priv; @@ -834,7 +851,7 @@ static inline struct b43_wldev *dev_to_b43_wldev(struct device *dev) return ssb_get_drvdata(ssb_dev); } -/* Is the device operating in a specified mode (IEEE80211_IF_TYPE_XXX). */ +/* Is the device operating in a specified mode (NL80211_IFTYPE_XXX). */ static inline int b43_is_mode(struct b43_wl *wl, int type) { return (wl->operating && wl->if_type == type); |