From eee41b49b80420e3e8c118d18dfacb7da43c1caa Mon Sep 17 00:00:00 2001 From: Shengzhou Liu Date: Mon, 2 Sep 2013 13:25:52 +0800 Subject: USB: fsl/ehci: fix failure of checking PHY_CLK_VALID during reinitialization In case of usb phy reinitialization: e.g. insmod usb-module(usb works well) -> rmmod usb-module -> insmod usb-module It found the PHY_CLK_VALID bit didn't work if it's not with the power-on reset. So we just check PHY_CLK_VALID bit during the stage with POR, this can be met by the tricky of checking FSL_SOC_USB_PRICTRL register. Signed-off-by: Shengzhou Liu Signed-off-by: Greg Kroah-Hartman --- drivers/usb/host/ehci-fsl.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c index d3166e693dcb..f2407b2e8a99 100644 --- a/drivers/usb/host/ehci-fsl.c +++ b/drivers/usb/host/ehci-fsl.c @@ -264,8 +264,9 @@ static int ehci_fsl_setup_phy(struct usb_hcd *hcd, if (pdata->have_sysif_regs && pdata->controller_ver && (phy_mode == FSL_USB2_PHY_ULPI)) { /* check PHY_CLK_VALID to get phy clk valid */ - if (!spin_event_timeout(in_be32(non_ehci + FSL_SOC_USB_CTRL) & - PHY_CLK_VALID, FSL_USB_PHY_CLK_TIMEOUT, 0)) { + if (!(spin_event_timeout(in_be32(non_ehci + FSL_SOC_USB_CTRL) & + PHY_CLK_VALID, FSL_USB_PHY_CLK_TIMEOUT, 0) || + in_be32(non_ehci + FSL_SOC_USB_PRICTRL))) { printk(KERN_WARNING "fsl-ehci: USB PHY clock invalid\n"); return -EINVAL; } -- cgit v1.2.3-55-g7522