From e03f9088e22ca7e2b0de826466540e2527518e52 Mon Sep 17 00:00:00 2001 From: Magnus Damm Date: Wed, 3 Dec 2014 21:18:03 +0900 Subject: irqchip: renesas-intc-irqpin: r8a7779 IRLM setup support Add r8a7779 specific support for IRLM bit configuration in the INTC-IRQPIN driver. Without this code we need special workaround code in arch/arm/mach-shmobile. The IRLM bit for the INTC hardware exists on various older SH-based SoCs and is used to select between two modes for the external interrupt pins IRQ0 to IRQ3: IRLM = 0: (default from reset on r8a7779) In this mode the pins IRQ0 to IRQ3 are used together to give a value between 0 and 15 to the SoC. External logic is required for masking. This mode is not supported by the INTC-IRQPIN driver. IRLM = 1: (needs this patch or configuration elsewhere) In this mode IRQ0 to IRQ3 operate as 4 individual external interrupt pins. In this mode the SMSC ethernet chip can be used via IRQ1 on r8a7779 Marzen. This mode is the only supported mode by the INTC-IRQPIN driver. For this patch to work the r8a7779 DTS needs to pass the ICR0 register as the last register bank. Signed-off-by: Magnus Damm Cc: Magnus Damm Cc: horms@verge.net.au Cc: jason@lakedaemon.net Link: http://lkml.kernel.org/r/20141203121803.5936.35881.sendpatchset@w520 Signed-off-by: Thomas Gleixner --- .../devicetree/bindings/interrupt-controller/renesas,intc-irqpin.txt | 5 +++++ 1 file changed, 5 insertions(+) (limited to 'Documentation/devicetree') diff --git a/Documentation/devicetree/bindings/interrupt-controller/renesas,intc-irqpin.txt b/Documentation/devicetree/bindings/interrupt-controller/renesas,intc-irqpin.txt index c73acd060093..4f7946ae8adc 100644 --- a/Documentation/devicetree/bindings/interrupt-controller/renesas,intc-irqpin.txt +++ b/Documentation/devicetree/bindings/interrupt-controller/renesas,intc-irqpin.txt @@ -9,6 +9,11 @@ Required properties: - "renesas,intc-irqpin-r8a7778" (R-Car M1A) - "renesas,intc-irqpin-r8a7779" (R-Car H1) - "renesas,intc-irqpin-sh73a0" (SH-Mobile AG5) + +- reg: Base address and length of each register bank used by the external + IRQ pins driven by the interrupt controller hardware module. The base + addresses, length and number of required register banks varies with soctype. + - #interrupt-cells: has to be <2>: an interrupt index and flags, as defined in interrupts.txt in this directory -- cgit v1.2.3-55-g7522