From f07d1501292b3b0d3276ee0e537005526a45e242 Mon Sep 17 00:00:00 2001 From: Alexander Duyck Date: Fri, 12 Sep 2008 17:57:23 -0700 Subject: multiq: Further multiqueue cleanup This patch resolves a few issues found with multiq including wording suggestions and a problem seen in the allocation of queues. Signed-off-by: Alexander Duyck Signed-off-by: Jeff Kirsher Signed-off-by: David S. Miller --- Documentation/networking/multiqueue.txt | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-) (limited to 'Documentation/networking') diff --git a/Documentation/networking/multiqueue.txt b/Documentation/networking/multiqueue.txt index 8c2b06b77f61..4caa0e314cc2 100644 --- a/Documentation/networking/multiqueue.txt +++ b/Documentation/networking/multiqueue.txt @@ -29,15 +29,15 @@ Section 2: Qdisc support for multiqueue devices ----------------------------------------------- -Currently two qdiscs support multiqueue devices. The first is the default -pfifo_fast qdisc. This qdisc supports one qdisc per hardware queue. A new -round-robin qdisc, sch_multiq also supports multiple hardware queues. The +Currently two qdiscs are optimized for multiqueue devices. The first is the +default pfifo_fast qdisc. This qdisc supports one qdisc per hardware queue. +A new round-robin qdisc, sch_multiq also supports multiple hardware queues. The qdisc is responsible for classifying the skb's and then directing the skb's to bands and queues based on the value in skb->queue_mapping. Use this field in the base driver to determine which queue to send the skb to. -sch_multiq has been added for hardware that wishes to avoid unnecessary -requeuing. It will cycle though the bands and verify that the hardware queue +sch_multiq has been added for hardware that wishes to avoid head-of-line +blocking. It will cycle though the bands and verify that the hardware queue associated with the band is not stopped prior to dequeuing a packet. On qdisc load, the number of bands is based on the number of queues on the @@ -63,8 +63,8 @@ band 1 => queue 1 band 2 => queue 2 band 3 => queue 3 -Traffic will begin flowing through each queue if your base device has either -the default simple_tx_hash or a custom netdev->select_queue() defined. +Traffic will begin flowing through each queue based on either the simple_tx_hash +function or based on netdev->select_queue() if you have it defined. The behavior of tc filters remains the same. However a new tc action, skbedit, has been added. Assuming you wanted to route all traffic to a -- cgit v1.2.3-55-g7522