From b33488eb5c27c13c3e88cdf29d344ccdcb0859f2 Mon Sep 17 00:00:00 2001 From: Frank Gevaerts Date: Fri, 30 Jun 2006 02:34:45 -0700 Subject: [PATCH] USB: ipaq.c timing parameters Adds configurable waiting periods to the ipaq connection code. These are not needed when the pocketpc device is running normally when plugged in, but they need extra delays if they are physically connected while rebooting. There are two parameters : * initial_wait : this is the delay before the driver attemts to start the connection. This is needed because the pocktpc device takes much longer to boot if the driver starts sending control packets too soon. * connect_retries : this is the number of times the control urb is retried before finally giving up. The patch also adds a 1 second delay between retries. I'm not sure if the cases where this patch is useful are general enough to include this in the kernel. Signed-off-by: Frank Gevaerts Signed-off-by: Andrew Morton Signed-off-by: Greg Kroah-Hartman --- drivers/usb/serial/ipaq.c | 12 +++++++++++- 1 file changed, 11 insertions(+), 1 deletion(-) (limited to 'drivers/usb/serial') diff --git a/drivers/usb/serial/ipaq.c b/drivers/usb/serial/ipaq.c index c021905f0637..65beea6e54d1 100644 --- a/drivers/usb/serial/ipaq.c +++ b/drivers/usb/serial/ipaq.c @@ -70,6 +70,8 @@ static __u16 product, vendor; static int debug; +static int connect_retries = KP_RETRIES; +static int initial_wait; /* Function prototypes for an ipaq */ static int ipaq_open (struct usb_serial_port *port, struct file *filp); @@ -582,7 +584,7 @@ static int ipaq_open(struct usb_serial_port *port, struct file *filp) struct ipaq_private *priv; struct ipaq_packet *pkt; int i, result = 0; - int retries = KP_RETRIES; + int retries = connect_retries; dbg("%s - port %d", __FUNCTION__, port->number); @@ -646,6 +648,7 @@ static int ipaq_open(struct usb_serial_port *port, struct file *filp) port->read_urb->transfer_buffer_length = URBDATA_SIZE; port->bulk_out_size = port->write_urb->transfer_buffer_length = URBDATA_SIZE; + msleep(1000*initial_wait); /* Start reading from the device */ usb_fill_bulk_urb(port->read_urb, serial->dev, usb_rcvbulkpipe(serial->dev, port->bulk_in_endpointAddress), @@ -672,6 +675,7 @@ static int ipaq_open(struct usb_serial_port *port, struct file *filp) } return 0; } + msleep(1000); } err("%s - failed doing control urb, error %d", __FUNCTION__, result); goto error; @@ -967,3 +971,9 @@ MODULE_PARM_DESC(vendor, "User specified USB idVendor"); module_param(product, ushort, 0); MODULE_PARM_DESC(product, "User specified USB idProduct"); + +module_param(connect_retries, int, S_IRUGO|S_IWUSR); +MODULE_PARM_DESC(connect_retries, "Maximum number of connect retries (one second each)"); + +module_param(initial_wait, int, S_IRUGO|S_IWUSR); +MODULE_PARM_DESC(initial_wait, "Time to wait before attempting a connection (in seconds)"); -- cgit v1.2.3-55-g7522