From 6a2e9b738cb5c929df73b6acabdd8f9a4e9a0416 Mon Sep 17 00:00:00 2001 From: Sam Ravnborg Date: Mon, 11 Jul 2005 21:13:56 -0700 Subject: [NET]: move config options out to individual protocols Move the protocol specific config options out to the specific protocols. With this change net/Kconfig now starts to become readable and serve as a good basis for further re-structuring. The menu structure is left almost intact, except that indention is fixed in most cases. Most visible are the INET changes where several "depends on INET" are replaced with a single ifdef INET / endif pair. Several new files were created to accomplish this change - they are small but serve the purpose that config options are now distributed out where they belongs. Signed-off-by: Sam Ravnborg Signed-off-by: David S. Miller --- net/x25/Kconfig | 36 ++++++++++++++++++++++++++++++++++++ 1 file changed, 36 insertions(+) create mode 100644 net/x25/Kconfig (limited to 'net/x25/Kconfig') diff --git a/net/x25/Kconfig b/net/x25/Kconfig new file mode 100644 index 000000000000..e6759c9660bb --- /dev/null +++ b/net/x25/Kconfig @@ -0,0 +1,36 @@ +# +# CCITT X.25 Packet Layer +# + +config X25 + tristate "CCITT X.25 Packet Layer (EXPERIMENTAL)" + depends on EXPERIMENTAL + ---help--- + X.25 is a set of standardized network protocols, similar in scope to + frame relay; the one physical line from your box to the X.25 network + entry point can carry several logical point-to-point connections + (called "virtual circuits") to other computers connected to the X.25 + network. Governments, banks, and other organizations tend to use it + to connect to each other or to form Wide Area Networks (WANs). Many + countries have public X.25 networks. X.25 consists of two + protocols: the higher level Packet Layer Protocol (PLP) (say Y here + if you want that) and the lower level data link layer protocol LAPB + (say Y to "LAPB Data Link Driver" below if you want that). + + You can read more about X.25 at and + . + Information about X.25 for Linux is contained in the files + and + . + + One connects to an X.25 network either with a dedicated network card + using the X.21 protocol (not yet supported by Linux) or one can do + X.25 over a standard telephone line using an ordinary modem (say Y + to "X.25 async driver" below) or over Ethernet using an ordinary + Ethernet card and the LAPB over Ethernet (say Y to "LAPB Data Link + Driver" and "LAPB over Ethernet driver" below). + + To compile this driver as a module, choose M here: the module + will be called x25. If unsure, say N. + + -- cgit v1.2.3-55-g7522