diff options
Diffstat (limited to 'src/serverconfig.h')
-rw-r--r-- | src/serverconfig.h | 18 |
1 files changed, 12 insertions, 6 deletions
diff --git a/src/serverconfig.h b/src/serverconfig.h index 0cbb320..31708de 100644 --- a/src/serverconfig.h +++ b/src/serverconfig.h @@ -6,16 +6,22 @@ // +++++ Performance/memory related #define SERVER_MAX_CLIENTS 4000 #define SERVER_MAX_IMAGES 5000 -#define SERVER_MAX_ALTS 100 +#define SERVER_MAX_ALTS 50 // +++++ Uplink handling (proxy mode) -#define SERVER_UPLINK_FAIL_INCREASE 5 // On server failure, increase numFails by this value -#define SERVER_BAD_UPLINK_THRES 40 // Thresold for numFails at which we ignore a server for the time span below +#define SERVER_GLOBAL_DUP_TIME 6 // How many seconds to wait before changing global fail counter again +#define SERVER_BAD_UPLINK_MIN 10 // Thresold for fails at which we start ignoring the server occasionally +#define SERVER_BAD_UPLINK_MAX 20 // Hard block server if it failed this many times +#define SERVER_BAD_UPLINK_LOCAL_BLOCK 10 // If a server didn't supply the requested image this many times, block it for some time #define SERVER_BAD_UPLINK_IGNORE 180 // How many seconds is a server ignored -#define SERVER_MAX_UPLINK_QUEUE 1500 // Maximum number of queued requests per uplink +#define UPLINK_MAX_QUEUE 500 // Maximum number of queued requests per uplink +#define UPLINK_MAX_CLIENTS_PER_REQUEST 32 // Maximum number of clients that can attach to one uplink request #define SERVER_UPLINK_QUEUELEN_THRES 900 // Threshold where we start dropping incoming clients #define SERVER_MAX_PENDING_ALT_CHECKS 500 // Length of queue for pending alt checks requested by uplinks -#define SERVER_CACHE_MAP_SAVE_INTERVAL 90 +// Wait a maximum of 5 minutes before saving cache map (if data was received at all) +#define CACHE_MAP_MAX_SAVE_DELAY 300 +// If more than 500MB have been received from uplink without saving cache map, do so +#define CACHE_MAP_MAX_UNSAVED_BYTES ((uint64_t)500 * 1000 * 1000) // Time in ms to wait for a read/write call to complete on an uplink connection #define SOCKET_TIMEOUT_UPLINK 5000 @@ -33,7 +39,7 @@ #define SERVER_RTT_PROBES 5 // How many probes to average over #define SERVER_RTT_INTERVAL_INIT 5 // Initial interval between probes #define SERVER_RTT_INTERVAL_MAX 45 // Maximum interval between probes -#define SERVER_RTT_BACKOFF_COUNT 5 // If we can't reach any uplink server this many times, consider the uplink bad +#define SERVER_RTT_MAX_UNREACH 10 // If no server was reachable this many times, stop RTT measurements for a while #define SERVER_RTT_INTERVAL_FAILED 180 // Interval to use if no uplink server is reachable for above many times #define SERVER_REMOTE_IMAGE_CHECK_CACHETIME 120 // 2 minutes |