/*
* Driver for the MMC / SD / SDIO cell found in:
*
* TC6393XB TC6391XB TC6387XB T7L66XB ASIC3
*
* Copyright (C) 2015-17 Renesas Electronics Corporation
* Copyright (C) 2016-17 Sang Engineering, Wolfram Sang
* Copyright (C) 2016-17 Horms Solutions, Simon Horman
* Copyright (C) 2007 Ian Molton
* Copyright (C) 2004 Ian Molton
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*
*/
#ifndef TMIO_MMC_H
#define TMIO_MMC_H
#include <linux/dmaengine.h>
#include <linux/highmem.h>
#include <linux/mutex.h>
#include <linux/pagemap.h>
#include <linux/scatterlist.h>
#include <linux/spinlock.h>
#include <linux/interrupt.h>
#define CTL_SD_CMD 0x00
#define CTL_ARG_REG 0x04
#define CTL_STOP_INTERNAL_ACTION 0x08
#define CTL_XFER_BLK_COUNT 0xa
#define CTL_RESPONSE 0x0c
/* driver merges STATUS and following STATUS2 */
#define CTL_STATUS 0x1c
/* driver merges IRQ_MASK and following IRQ_MASK2 */
#define CTL_IRQ_MASK 0x20
#define CTL_SD_CARD_CLK_CTL 0x24
#define CTL_SD_XFER_LEN 0x26
#define CTL_SD_MEM_CARD_OPT 0x28
#define CTL_SD_ERROR_DETAIL_STATUS 0x2c
#define CTL_SD_DATA_PORT 0x30
#define CTL_TRANSACTION_CTL 0x34
#define CTL_SDIO_STATUS 0x36
#define CTL_SDIO_IRQ_MASK 0x38
#define CTL_DMA_ENABLE 0xd8
#define CTL_RESET_SD 0xe0
#define CTL_VERSION 0xe2
#define CTL_SDIO_REGS 0x100
#define CTL_CLK_AND_WAIT_CTL 0x138
#define CTL_RESET_SDIO 0x1e0
/* Definitions for values the CTL_STOP_INTERNAL_ACTION register can take */
#define TMIO_STOP_STP BIT(0)
#define TMIO_STOP_SEC BIT(8)
/* Definitions for values the CTL_STATUS register can take */
#define TMIO_STAT_CMDRESPEND BIT(0)
#define TMIO_STAT_DATAEND BIT(2)
#define TMIO_STAT_CARD_REMOVE BIT(3)
#define TMIO_STAT_CARD_INSERT BIT(4)
#define TMIO_STAT_SIGSTATE BIT(5)
#define TMIO_STAT_WRPROTECT BIT(7)
#define TMIO_STAT_CARD_REMOVE_A BIT(8)
#define TMIO_STAT_CARD_INSERT_A BIT(9)
#define TMIO_STAT_SIGSTATE_A BIT(10)
/* These belong technically to CTL_STATUS2, but the driver merges them */
#define TMIO_STAT_CMD_IDX_ERR BIT(16)
#define TMIO_STAT_CRCFAIL BIT(17)
#define TMIO_STAT_STOPBIT_ERR BIT(18)
#define TMIO_STAT_DATATIMEOUT BIT(19)
#define TMIO_STAT_RXOVERFLOW BIT(20)
#define TMIO_STAT_TXUNDERRUN BIT(21)
#define TMIO_STAT_CMDTIMEOUT BIT(22)
#define TMIO_STAT_DAT0 BIT(23) /* only known on R-Car so far */
#define TMIO_STAT_RXRDY BIT(24)
#define TMIO_STAT_TXRQ BIT(25)
#define TMIO_STAT_ILL_FUNC BIT(29) /* only when !TMIO_MMC_HAS_IDLE_WAIT */
#define TMIO_STAT_SCLKDIVEN BIT(29) /* only when TMIO_MMC_HAS_IDLE_WAIT */
#define TMIO_STAT_CMD_BUSY BIT(30)
#define TMIO_STAT_ILL_ACCESS BIT(31)
/* Definitions for values the CTL_SD_CARD_CLK_CTL register can take */
#define CLK_CTL_DIV_MASK 0xff
#define CLK_CTL_SCLKEN BIT(8)
/* Definitions for values the CTL_SD_MEM_CARD_OPT register can take */
#define CARD_OPT_WIDTH8 BIT(13)
#define CARD_OPT_WIDTH BIT(15)
/* Definitions for values the CTL_SDIO_STATUS register can take */
#define TMIO_SDIO_STAT_IOIRQ 0x0001
#define TMIO_SDIO_STAT_EXPUB52 0x4000
#define TMIO_SDIO_STAT_EXWT 0x8000
#define TMIO_SDIO_MASK_ALL 0xc007
#define TMIO_SDIO_SETBITS_MASK 0x0006
/* Definitions for values the CTL_DMA_ENABLE register can take */
#define DMA_ENABLE_DMASDRW BIT(1)
/* Define some IRQ masks */
/* This is the mask used at reset by the chip */
#define TMIO_MASK_ALL 0x837f031d
#define TMIO_MASK_READOP (TMIO_STAT_RXRDY | TMIO_STAT_DATAEND)
#define TMIO_MASK_WRITEOP (TMIO_STAT_TXRQ | TMIO_STAT_DATAEND)
#define TMIO_MASK_CMD (TMIO_STAT_CMDRESPEND | TMIO_STAT_CMDTIMEOUT | \
TMIO_STAT_CARD_REMOVE | TMIO_STAT_CARD_INSERT)
#define TMIO_MASK_IRQ (TMIO_MASK_READOP | TMIO_MASK_WRITEOP | TMIO_MASK_CMD)
struct tmio_mmc_data;
struct tmio_mmc_host;
struct tmio_mmc_dma {
enum dma_slave_buswidth dma_buswidth;
bool (*filter)(struct dma_chan *chan, void *arg);
void (*enable)(struct tmio_mmc_host *host, bool enable);
};
struct tmio_mmc_dma_ops {
void (*start)(struct tmio_mmc_host *host, struct mmc_data *data);
void (*enable)(struct tmio_mmc_host *host, bool enable);
void (*request)(struct tmio_mmc_host *host,
struct tmio_mmc_data *pdata);
void (*release)(struct tmio_mmc_host *host);
void (*abort)(struct tmio_mmc_host *host);
void (*dataend)(struct tmio_mmc_host *host);
};
struct tmio_mmc_host {
void __iomem *ctl;
struct mmc_command *cmd;
struct mmc_request *mrq;
struct mmc_data *data;
struct mmc_host *mmc;
/* Callbacks for clock / power control */
void (*set_pwr)(struct platform_device *host, int state);
void (*set_clk_div)(struct platform_device *host, int state);
/* pio related stuff */
struct scatterlist *sg_ptr;
struct scatterlist *sg_orig;
unsigned int sg_len;
unsigned int sg_off;
unsigned long bus_shift;
struct platform_device *pdev;
struct tmio_mmc_data *pdata;
struct tmio_mmc_dma *dma;
/* DMA support */
bool force_pio;
struct dma_chan *chan_rx;
struct dma_chan *chan_tx;
struct completion dma_dataend;
struct tasklet_struct dma_complete;
struct tasklet_struct dma_issue;
struct scatterlist bounce_sg;
u8 *bounce_buf;
/* Track lost interrupts */
struct delayed_work delayed_reset_work;
struct work_struct done;
/* Cache */
u32 sdcard_irq_mask;
u32 sdio_irq_mask;
unsigned int clk_cache;
spinlock_t lock; /* protect host private data */
unsigned long last_req_ts;
struct mutex ios_lock; /* protect set_ios() context */
bool native_hotplug;
bool sdio_irq_enabled;
u32 scc_tappos;
/* Mandatory callback */
int (*clk_enable)(struct tmio_mmc_host *host);
/* Optional callbacks */
unsigned int (*clk_update)(struct tmio_mmc_host *host,
unsigned int new_clock);
void (*clk_disable)(struct tmio_mmc_host *host);
int (*multi_io_quirk)(struct mmc_card *card,
unsigned int direction, int blk_size);
int (*card_busy)(struct mmc_host *mmc);
int (*start_signal_voltage_switch)(struct mmc_host *mmc,
struct mmc_ios *ios);
int (*write16_hook)(struct tmio_mmc_host *host, int addr);
void (*hw_reset)(struct tmio_mmc_host *host);
void (*prepare_tuning)(struct tmio_mmc_host *host, unsigned long tap);
bool (*check_scc_error)(struct tmio_mmc_host *host);
/*
* Mandatory callback for tuning to occur which is optional for SDR50
* and mandatory for SDR104.
*/
unsigned int (*init_tuning)(struct tmio_mmc_host *host);
int (*select_tuning)(struct tmio_mmc_host *host);
/* Tuning values: 1 for success, 0 for failure */
DECLARE_BITMAP(taps, BITS_PER_BYTE * sizeof(long));
unsigned int tap_num;
const struct tmio_mmc_dma_ops *dma_ops;
};
struct tmio_mmc_host *tmio_mmc_host_alloc(struct platform_device *pdev);
void tmio_mmc_host_free(struct tmio_mmc_host *host);
int tmio_mmc_host_probe(struct tmio_mmc_host *host,
struct tmio_mmc_data *pdata,
const struct tmio_mmc_dma_ops *dma_ops);
void tmio_mmc_host_remove(struct tmio_mmc_host *host);
void tmio_mmc_do_data_irq(struct tmio_mmc_host *host);
void tmio_mmc_enable_mmc_irqs(struct tmio_mmc_host *host, u32 i);
void tmio_mmc_disable_mmc_irqs(struct tmio_mmc_host *host, u32 i);
irqreturn_t tmio_mmc_irq(int irq, void *devid);
static inline char *tmio_mmc_kmap_atomic(struct scatterlist *sg,
unsigned long *flags)
{
local_irq_save(*flags);
return kmap_atomic(sg_page(sg)) + sg->offset;
}
static inline void tmio_mmc_kunmap_atomic(struct scatterlist *sg,
unsigned long *flags, void *virt)
{
kunmap_atomic(virt - sg->offset);
local_irq_restore(*flags);
}
#ifdef CONFIG_PM
int tmio_mmc_host_runtime_suspend(struct device *dev);
int tmio_mmc_host_runtime_resume(struct device *dev);
#endif
static inline u16 sd_ctrl_read16(struct tmio_mmc_host *host, int addr)
{
return readw(host->ctl + (addr << host->bus_shift));
}
static inline void sd_ctrl_read16_rep(struct tmio_mmc_host *host, int addr,
u16 *buf, int count)
{
readsw(host->ctl + (addr << host->bus_shift), buf, count);
}
static inline u32 sd_ctrl_read16_and_16_as_32(struct tmio_mmc_host *host,
int addr)
{
return readw(host->ctl + (addr << host->bus_shift)) |
readw(host->ctl + ((addr + 2) << host->bus_shift)) << 16;
}
static inline void sd_ctrl_read32_rep(struct tmio_mmc_host *host, int addr,
u32 *buf, int count)
{
readsl(host->ctl + (addr << host->bus_shift), buf, count);
}
static inline void sd_ctrl_write16(struct tmio_mmc_host *host, int addr,
u16 val)
{
/* If there is a hook and it returns non-zero then there
* is an error and the write should be skipped
*/
if (host->write16_hook && host->write16_hook(host, addr))
return;
writew(val, host->ctl + (addr << host->bus_shift));
}
static inline void sd_ctrl_write16_rep(struct tmio_mmc_host *host, int addr,
u16 *buf, int count)
{
writesw(host->ctl + (addr << host->bus_shift), buf, count);
}
static inline void sd_ctrl_write32_as_16_and_16(struct tmio_mmc_host *host,
int addr, u32 val)
{
writew(val & 0xffff, host->ctl + (addr << host->bus_shift));
writew(val >> 16, host->ctl + ((addr + 2) << host->bus_shift));
}
static inline void sd_ctrl_write32_rep(struct tmio_mmc_host *host, int addr,
const u32 *buf, int count)
{
writesl(host->ctl + (addr << host->bus_shift), buf, count);
}
#endif
