mdio_bus: Issue GPIO RESET to PHYs.

Some boards [1] leave the PHYs at an invalid state
during system power-up or reset thus causing unreliability
issues with the PHY which manifests as PHY not being detected
or link not functional. To fix this, these PHYs need to be RESET
via a GPIO connected to the PHY's RESET pin.

Some boards have a single GPIO controlling the PHY RESET pin of all
PHYs on the bus whereas some others have separate GPIOs controlling
individual PHY RESETs.

In both cases, the RESET de-assertion cannot be done in the PHY driver
as the PHY will not probe till its reset is de-asserted.
So do the RESET de-assertion in the MDIO bus driver.

[1] - am572x-idk, am571x-idk, a437x-idk

Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 7 insertions, 0 deletions

diff --git a/include/linux/phy.h b/include/linux/phy.h
index 624cecf69c28..37ca77d86983 100644
--- a/include/linux/phy.h
+++ b/include/linux/phy.h
@@ -217,6 +217,13 @@ struct mii_bus {
 	 * matching its address
 	 */
 	int irq[PHY_MAX_ADDR];
+
+	/* GPIO reset pulse width in microseconds */
+	int reset_delay_us;
+	/* Number of reset GPIOs */
+	int num_reset_gpios;
+	/* Array of RESET GPIO descriptors */
+	struct gpio_desc **reset_gpiod;
 };
 #define to_mii_bus(d) container_of(d, struct mii_bus, dev)