diff options
Diffstat (limited to 'Documentation/kernel-parameters.txt')
| -rw-r--r-- | Documentation/kernel-parameters.txt | 26 |
1 files changed, 21 insertions, 5 deletions
diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt index 794403166a8f..82b42c958d1c 100644 --- a/Documentation/kernel-parameters.txt +++ b/Documentation/kernel-parameters.txt @@ -1054,6 +1054,12 @@ bytes respectively. Such letter suffixes can also be entirely omitted. the driver will use only 32-bit accessors to read/write the device registers. + meson,<addr> + Start an early, polled-mode console on a meson serial + port at the specified address. The serial port must + already be setup and configured. Options are not yet + supported. + msm_serial,<addr> Start an early, polled-mode console on an msm serial port at the specified address. The serial port @@ -1787,6 +1793,13 @@ bytes respectively. Such letter suffixes can also be entirely omitted. PCI device 00:14.0 write the parameter as: ivrs_hpet[0]=00:14.0 + ivrs_acpihid [HW,X86_64] + Provide an override to the ACPI-HID:UID<->DEVICE-ID + mapping provided in the IVRS ACPI table. For + example, to map UART-HID:UID AMD0020:0 to + PCI device 00:14.5 write the parameter as: + ivrs_acpihid[00:14.5]=AMD0020:0 + js= [HW,JOY] Analog joystick See Documentation/input/joystick.txt. @@ -2161,6 +2174,14 @@ bytes respectively. Such letter suffixes can also be entirely omitted. [KNL,SH] Allow user to override the default size for per-device physically contiguous DMA buffers. + memhp_default_state=online/offline + [KNL] Set the initial state for the memory hotplug + onlining policy. If not specified, the default value is + set according to the + CONFIG_MEMORY_HOTPLUG_DEFAULT_ONLINE kernel config + option. + See Documentation/memory-hotplug.txt. + memmap=exactmap [KNL,X86] Enable setting of an exact E820 memory map, as specified by the user. Such memmap=exactmap lines can be constructed based on @@ -2944,11 +2965,6 @@ bytes respectively. Such letter suffixes can also be entirely omitted. for broken drivers that don't call it. skip_isa_align [X86] do not align io start addr, so can handle more pci cards - firmware [ARM] Do not re-enumerate the bus but instead - just use the configuration from the - bootloader. This is currently used on - IXP2000 systems where the bus has to be - configured a certain way for adjunct CPUs. noearly [X86] Don't do any early type 1 scanning. This might help on some broken boards which machine check when some devices' config space |