diff options
Diffstat (limited to 'arch/powerpc/kernel/exceptions-64s.S')
| -rw-r--r-- | arch/powerpc/kernel/exceptions-64s.S | 95 |
1 files changed, 7 insertions, 88 deletions
diff --git a/arch/powerpc/kernel/exceptions-64s.S b/arch/powerpc/kernel/exceptions-64s.S index 15c5a4f6de01..fea8a69df4b2 100644 --- a/arch/powerpc/kernel/exceptions-64s.S +++ b/arch/powerpc/kernel/exceptions-64s.S @@ -19,7 +19,7 @@ * We layout physical memory as follows: * 0x0000 - 0x00ff : Secondary processor spin code * 0x0100 - 0x2fff : pSeries Interrupt prologs - * 0x3000 - 0x5fff : interrupt support, iSeries and common interrupt prologs + * 0x3000 - 0x5fff : interrupt support common interrupt prologs * 0x6000 - 0x6fff : Initial (CPU0) segment table * 0x7000 - 0x7fff : FWNMI data area * 0x8000 - : Early init and support code @@ -458,6 +458,7 @@ machine_check_common: bl .machine_check_exception b .ret_from_except + STD_EXCEPTION_COMMON_LITE(0x500, hardware_interrupt, do_IRQ) STD_EXCEPTION_COMMON_LITE(0x900, decrementer, .timer_interrupt) STD_EXCEPTION_COMMON(0xa00, trap_0a, .unknown_exception) STD_EXCEPTION_COMMON(0xb00, trap_0b, .unknown_exception) @@ -672,12 +673,6 @@ _GLOBAL(slb_miss_realmode) ld r10,PACA_EXSLB+EX_LR(r13) ld r3,PACA_EXSLB+EX_R3(r13) lwz r9,PACA_EXSLB+EX_CCR(r13) /* get saved CR */ -#ifdef CONFIG_PPC_ISERIES -BEGIN_FW_FTR_SECTION - ld r11,PACALPPACAPTR(r13) - ld r11,LPPACASRR0(r11) /* get SRR0 value */ -END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES) -#endif /* CONFIG_PPC_ISERIES */ mtlr r10 @@ -690,12 +685,6 @@ END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES) mtcrf 0x01,r9 /* slb_allocate uses cr0 and cr7 */ .machine pop -#ifdef CONFIG_PPC_ISERIES -BEGIN_FW_FTR_SECTION - mtspr SPRN_SRR0,r11 - mtspr SPRN_SRR1,r12 -END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES) -#endif /* CONFIG_PPC_ISERIES */ ld r9,PACA_EXSLB+EX_R9(r13) ld r10,PACA_EXSLB+EX_R10(r13) ld r11,PACA_EXSLB+EX_R11(r13) @@ -704,13 +693,7 @@ END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES) rfid b . /* prevent speculative execution */ -2: -#ifdef CONFIG_PPC_ISERIES -BEGIN_FW_FTR_SECTION - b unrecov_slb -END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES) -#endif /* CONFIG_PPC_ISERIES */ - mfspr r11,SPRN_SRR0 +2: mfspr r11,SPRN_SRR0 ld r10,PACAKBASE(r13) LOAD_HANDLER(r10,unrecov_slb) mtspr SPRN_SRR0,r10 @@ -727,20 +710,6 @@ unrecov_slb: bl .unrecoverable_exception b 1b - .align 7 - .globl hardware_interrupt_common - .globl hardware_interrupt_entry -hardware_interrupt_common: - EXCEPTION_PROLOG_COMMON(0x500, PACA_EXGEN) - FINISH_NAP -hardware_interrupt_entry: - DISABLE_INTS -BEGIN_FTR_SECTION - bl .ppc64_runlatch_on -END_FTR_SECTION_IFSET(CPU_FTR_CTRL) - addi r3,r1,STACK_FRAME_OVERHEAD - bl .do_IRQ - b .ret_from_except_lite #ifdef CONFIG_PPC_970_NAP power4_fixup_nap: @@ -913,11 +882,7 @@ END_MMU_FTR_SECTION_IFCLR(MMU_FTR_SLB) andis. r0,r0,NMI_MASK@h /* (i.e. an irq when soft-disabled) */ bne 77f /* then don't call hash_page now */ - /* - * On iSeries, we soft-disable interrupts here, then - * hard-enable interrupts so that the hash_page code can spin on - * the hash_table_lock without problems on a shared processor. - */ + /* We run with interrupts both soft and hard disabled */ DISABLE_INTS /* @@ -956,25 +921,11 @@ END_MMU_FTR_SECTION_IFCLR(MMU_FTR_SLB) bl .hash_page /* build HPTE if possible */ cmpdi r3,0 /* see if hash_page succeeded */ -BEGIN_FW_FTR_SECTION - /* - * If we had interrupts soft-enabled at the point where the - * DSI/ISI occurred, and an interrupt came in during hash_page, - * handle it now. - * We jump to ret_from_except_lite rather than fast_exception_return - * because ret_from_except_lite will check for and handle pending - * interrupts if necessary. - */ - beq 13f -END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES) - -BEGIN_FW_FTR_SECTION /* * Here we have interrupts hard-disabled, so it is sufficient * to restore paca->{soft,hard}_enable and get out. */ beq fast_exc_return_irq /* Return from exception on success */ -END_FW_FTR_SECTION_IFCLR(FW_FEATURE_ISERIES) /* For a hash failure, we don't bother re-enabling interrupts */ ble- 12f @@ -1141,51 +1092,19 @@ _GLOBAL(do_stab_bolted) .= 0x7000 .globl fwnmi_data_area fwnmi_data_area: -#endif /* defined(CONFIG_PPC_PSERIES) || defined(CONFIG_PPC_POWERNV) */ - - /* iSeries does not use the FWNMI stuff, so it is safe to put - * this here, even if we later allow kernels that will boot on - * both pSeries and iSeries */ -#ifdef CONFIG_PPC_ISERIES - . = LPARMAP_PHYS - .globl xLparMap -xLparMap: - .quad HvEsidsToMap /* xNumberEsids */ - .quad HvRangesToMap /* xNumberRanges */ - .quad STAB0_PAGE /* xSegmentTableOffs */ - .zero 40 /* xRsvd */ - /* xEsids (HvEsidsToMap entries of 2 quads) */ - .quad PAGE_OFFSET_ESID /* xKernelEsid */ - .quad PAGE_OFFSET_VSID /* xKernelVsid */ - .quad VMALLOC_START_ESID /* xKernelEsid */ - .quad VMALLOC_START_VSID /* xKernelVsid */ - /* xRanges (HvRangesToMap entries of 3 quads) */ - .quad HvPagesToMap /* xPages */ - .quad 0 /* xOffset */ - .quad PAGE_OFFSET_VSID << (SID_SHIFT - HW_PAGE_SHIFT) /* xVPN */ - -#endif /* CONFIG_PPC_ISERIES */ -#if defined(CONFIG_PPC_PSERIES) || defined(CONFIG_PPC_POWERNV) /* pseries and powernv need to keep the whole page from * 0x7000 to 0x8000 free for use by the firmware */ . = 0x8000 #endif /* defined(CONFIG_PPC_PSERIES) || defined(CONFIG_PPC_POWERNV) */ -/* - * Space for CPU0's segment table. - * - * On iSeries, the hypervisor must fill in at least one entry before - * we get control (with relocate on). The address is given to the hv - * as a page number (see xLparMap above), so this must be at a - * fixed address (the linker can't compute (u64)&initial_stab >> - * PAGE_SHIFT). - */ - . = STAB0_OFFSET /* 0x8000 */ +/* Space for CPU0's segment table */ + .balign 4096 .globl initial_stab initial_stab: .space 4096 + #ifdef CONFIG_PPC_POWERNV _GLOBAL(opal_mc_secondary_handler) HMT_MEDIUM |